87 535is - getting started
-
These pistons (and cam, cam sprocket) are custom made by Paul Burke with Imagineering
Compression ratio with these pistons on the M30B35 head is 10.5:1
Don't know about weight but they are forged
No boring and prob no honing as the block is a 95,000 mile block
All new rings and wrist pins. Crank bearings will be determined.
-
It wouldn't require more fuel, it would be using the standard quantity of fuel more efficiently so no changes there, timing tables could likely be advanced everywhere from the conservative factory values except for around a particular 3000-4500 rpm range where BMW SOHC engines can be prone to knock.
merl, do you ever attend the Concours BMW car show? You should consider entering your car, I think it would be a huge hit
-
It actually will want more fuel at higher RPM. Enough that 24lb/hr injectors are recommended... I can get away with standard injectors (19lb) but you run out at high RPM.
I will be running Motronic 1.3 with a Miller WAR chip. With the WAR Chip I should be able to dial in enough timing to not knock or ping (I hope).... I also will have an adjustable Cam sprocket to dial in the cam exactly. I know you can get away with a 10:1 motor with a standard ECU, especially if you are running Motronic 1.3 but not with this much work done.
With the head porting, aggresive cam, and pistons we have to have control on the computer. Miller WAR is plenty for this build. I looked at Megasquirt as well but I was able to order this stuff as a package including the Miller WAR/MAF ... Also there are proven maps for this build for the Miller stuff.
Never considered the Concours as the body on the car is not much to look at ... not horrible but not great.
-
I will when they are received ... I do not have an ETA yet as they have to make the pistons and cam
Why get an 'e' when you can get an 'i'
/e30 humor
-
Why get an 'e' when you can get an 'i'
/e30 humor
Don't hating on the ETA
Liking the progress!! -
Motor completely disconnected except for the transmission. Pull the bolts on the bell housing, pull motor !! Soon !!
Still have trim work to do
Wiring
Diff
Vacuum brakes
clean engine bay
Mount gauges
new fuel lines
order radiator
electric fan
mount Hartge spoiler
Remove spoiler
Have bumpers and spoiler painted
and .. oh ya .. build motor.
Uggghhh, it's still a long road. Gonna have to put some hours in.
-
oh definitely not. It was such a breeze to take the engine and trans out in 1 piece and re-install it as 1 piece. You can sit down and do a proper job replacing seals and things when its out of the car too. the next time I need a clutch I will be removing the engine and trans together again.
-
I don't care what anyone says ... getting the transmission out sucks .... a lot !!
I am going to put it in as one unit ... I will make it work. I am not going to put that transmission on after the motor is in .... Ugghhhhh
Drop the front subframe with motor attached to trans= boom.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login