Hello. My name is Dan, and today I doomsday prepped
-
If you have the tiniest hands in the history of the universe you could probably do it with the manifold on lol. I am not that sneaky.
I can try and sneak home for lunch and take some pics
-
Snap saves my lunch plans hooray. Also contributes to the type2 epidemic
-
Just take the manifold off it's not that bad.
I have a car that can be cannibalized for parts by your car lmk if you need anything.
i have literally 2.5 hours of day light when I get home on Thursday to get this fixed. i've never pulled an m50/s50 manifold, so I know it will be slower than that the first time around.
E30 Heater Core is 3/4" Heater hose
thank you sir!!!!!
If you have the tiniest hands in the history of the universe you could probably do it with the manifold on lol. I am not that sneaky.
I can try and sneak home for lunch and take some pics
like i said, i got the heater hoses on/off when I did the heater core from underneath so i'm crossing my fingers (i have big hands, btw)
Dan
-
Manifold is super easy job Dan
A few manifold nuts
Fuel lines
Throttle body
Vac line for FPR
ICV line to bottom of manifold
Bosh style connector on back of mani
That's about all I can think of
-
Manifold is super easy job Dan
A few manifold nuts
Fuel lines
Throttle body
Vac line for FPR
ICV line to bottom of manifold
Bosh style connector on back of mani
That's about all I can think of
Notes:
You can also just remove the two nuts that hold the injector rail in place and wedge that out of the way. No fuel anywhere.
You can remove the throttle cable from the throttle body instead of removing the whole thing. I think that's about a horse a piece.ÂIt is quite easy though, pending your wiring harness cover setup you may have to remove the cover.
-
If you have enough wiggle room in your fuel lines do what Ben said. Mine are too short so I usually get fed up and pull them in a fit of rage
-
thanks for the tips! i know its not bad, but we'll see what happens with the bypass plans tonight. got some extra coolant hose, brass fittings and clamps from the store at lunch.
Dan
-
I can swing by later if you need assistance. Just let me know.
-
if you'd swing by at least to bring the samples, that would be very helpful! I'm going to dive into this right when i get home.
Dan
-
If you have enough wiggle room in your fuel lines do what Ben said. Mine are too short so I usually get fed up and pull them in a fit of rage
Oh. Right. I changed to soft lines instead of those annoying metal ones that kept bugging me.Â
My statement may no longer apply -
crisis temporarily averted. with some 3/4 hose and random fittings (whatever they had in stock) i was able to make a bypass section. see you all on saturday.
Dan
-
yup, actually very easy with losing coolant from only that section of the system. also took it for a 10 min drive up to operating temp, then parked it - not going to touch it till Saturday morning for fear something else goes wrong.
Dan
-
-
I keep that hose repair tape in my on-board tool kit. It saved me once when I was in high school.
I didn't know it could be used for that...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login