E21 Project Thread - Part 2

[KaiserRolls]

I know that feel

[m42b32]

KaiserRolls said:

My living room looked 1% like that at one point, that train of thought was shut down rather quickly...you're lucky haha

[straight6pwr]

KaiserRolls said:

I know that feel

LOL best part of this is $$$$ on car parts taking priority over real living room furniture.

[andyhundley]

KaiserRolls said:

I know that feel

Mitch you should probably put that gallon of strawberry milk in the fridge before it goes bad.

[Earl]

[Bassboy3313]

Haha! This is awesome

[Bassboy3313]

andyhundley said:

Mitch you should probably put that gallon of strawberry milk in the fridge before it goes bad. 

Yes! Don't want another pb&j incident to happen again.

[Bassboy3313]

Started messing with the rear euro valance install this weekend. Using my brothers awesome snap-on body hammers and dollies I got some areas smoothed out on it. I think it will be easier once it's welded on the car. I went to sand down the edge of the car to bare metal for welding and ran into another Fat Bob curse.

DAMN YOU FAT BOB!!!!

Looks like he just chipped away some rust and bondo'd the hole shut. [emoji35] So I got in there and ground away all the bondo and proceeded to weld up the hole like it should of been in first place. Picture looks worse than in person. I basically built up weld beads and ground it flat to form the edge again for the valance to be welded to.

Progress pic

Then just for fun I tacked the valance on for how it may look. I need to take it off and get that edge flatter to fit against the car a lot better. Then from there I'll need to figure out the side pieces and it should be good to go.

[Jeff]

I need to know, who is fat bob?

[Bassboy3313]

Jeff said:

I need to know, who is fat bob?

The horrible previous owner of this car. Dumb high school kid who lost his license, so he decided to do terrible work to the car I have been discovering since day one of owning it.

[Jdesign]

[KaiserRolls]

[Bassboy3313]

When it comes to heating the workshed and garage in winter .... ^^^that is definitely me!

[Jeff]

Propane

[YoungCR]

And propane accessories

[B C]

[Bassboy3313]

Been sick all weekend, so couldnt do much outside. I ended up working more on the rear end and figuring out the axle lengths. Turns out, the distance from diff flange to hub flange is different on both ends. Only by 3/8" tho. One side I got 38mm shorter than stock and the other I got 28.5mm shorter than stock. At this point, I'm just gonna split the difference and get 2 axles the same length. Figure it's better to have 3/16" difference on both ends than 3/8" difference only on one end. Gonna be contacting Machine Service in Pewaukee this week for a quote on shortening my axles.

Sent from my SM-G930R4 using Tapatalk

[Jdesign]

I like the jig you made to size up the axles

[Bassboy3313]

And so it begins ...

Sent from my SM-G930R4 using Tapatalk

[KaiserRolls]

Pls document this really well, I have to do this soon (rebuilding them)