Fancy Stancy 325is
-
Yea, wait till I get some close ups of the awesome ebay turbo kit and suspension mods. My guess is the car looked pretty nice about 10 years ago. Last plate sticker is from 2013 with none underneath, so my guess is that is when the PO bought it. Apparently it was a grandson/grandfather project but the kid got in some trouble, I should probably give it a thorough search for baggies to find them before I inevitably get pulled over in it.
You should certainly do a cavity search. My E30 has "man made" hidden compartments between the rear seat and the trunk. The first time I got pulled over, the cops seemed "familiar" with the car as I got the full cavity search done for me with dogs and about 7 squads on the side of the freeway.
https://www.instagram.com/_jdesigner_/ http://nevertoolow.tumblr.com/
🥳SOLD BMW E24 633CSI - BMW M30B32 🧪SOLD HCH ES9 - 1.3 LDA
👽BMW E30 325IC - Toyota 1JZ-GTE ⏰ HONDA EF9 CIVIC SI - JDM B18C5
☠️BMW E36 318i - Ford 5.0 FE302 🚴♂️ GT-Labomba - 26x2.75 Freeride
🤹♀️SOLD BMW E36/7 Z3 - BMW M54B25 🧓SOLD BMW E10 2002 - BMW M10M05 -
Found a Dinan throttle body and chip so far, and I don't think the car ever started with the turbo because the icv was plugged so no air could get in... I will be removing the turbo because I don't have time or money to finish it right now.
Sent from my 831C using Tapatalk
-
Pics of engine bay!!!! And thats prolly a good decision on the cheap ebay turbo kit
https://www.instagram.com/_jdesigner_/ http://nevertoolow.tumblr.com/
🥳SOLD BMW E24 633CSI - BMW M30B32 🧪SOLD HCH ES9 - 1.3 LDA
👽BMW E30 325IC - Toyota 1JZ-GTE ⏰ HONDA EF9 CIVIC SI - JDM B18C5
☠️BMW E36 318i - Ford 5.0 FE302 🚴♂️ GT-Labomba - 26x2.75 Freeride
🤹♀️SOLD BMW E36/7 Z3 - BMW M54B25 🧓SOLD BMW E10 2002 - BMW M10M05 -
I got it up on jack stands yesterday. This lowrider life is a chore...
Engine bay shot
Dinan BBTB
Super awesome "boost controller" it says it is "high performance" I am a little skeptical.
Looks like they were nice vintage H&R spring before somebody took a grinder to them. Maybe it wasn't a complete set so he used half for each side of the car??
Sweet action boost piping
Dryer vent intake, easy routing at least. It had an ancient Spectre filter jammed on the end of it.
I am not sure how it works if you plug the ICV hose...
No milkshake here or oil cap so that seems good.
And a dead Fleet Farm battery to top it off.
My first steps have been to remove the janky security system. And get it up on jack stands to check out the bottom. It has some rust so i don't feel bad about it being a work beater. Next I am going to remove the turbo and exhaust and install the exhaust from my other car to run it N/A for now. I don't have time or money to finish it properly right now. I will see how it is with the Dinan chip and BBTB. I am pretty excited to drive a BMW again, even a junk one...
-
Was PO actually that big of a bum**** to put an Mpower cover on an M50? or is it actually swapped?
It's clearly swapped look at the time and detail spent on this car.
-
I don't think it is swapped. I think the car was pretty nice looking at some time5-10 years ago. The PO bought it in 2013 and never drove it, legally at least, because the license plate stickers go from '13 to '18 with none in between and the title was a recently acquired replacement.
Maybe I will get a surprise but I doubt it. I haven't gotten far enough into it to see the stamped numbers. It has a 413 red label ecu but who knows what the Dinan chip is set up for. It does have a tilt wheel!
-
TB is a nice touch!
-
Make sure to hang your muffler properly folks.
Also route exhaust "as the crow flies" for best results.
Shining that beast up.
Pretty nice no name turbo, it just says "WSHH" on the exhaust housing. They must be rated by the sound they make.
At least I have all of this reusable exhaust mounting hardware.
-
Wow. Looks like you are in for a rats nest of fun!!!
https://www.instagram.com/_jdesigner_/ http://nevertoolow.tumblr.com/
🥳SOLD BMW E24 633CSI - BMW M30B32 🧪SOLD HCH ES9 - 1.3 LDA
👽BMW E30 325IC - Toyota 1JZ-GTE ⏰ HONDA EF9 CIVIC SI - JDM B18C5
☠️BMW E36 318i - Ford 5.0 FE302 🚴♂️ GT-Labomba - 26x2.75 Freeride
🤹♀️SOLD BMW E36/7 Z3 - BMW M54B25 🧓SOLD BMW E10 2002 - BMW M10M05 -
I was working on the awesomely fun task of installing exhaust manifolds on a 24v engine, all 24 of them. I was able to see the VIN sticker on the back of the head. It appears to be the original. Bummer I was hoping it had been swapped long ago when a more caring PO had it. Oh well. I also pulled the plugs and they all looked nice. No cylinders steam cleaned...
-
I was working on the awesomely fun task of installing exhaust manifolds on a 24v engine, all 24 of them.
My favorite part about e36 24v motors.
Oh, wait... nope. Got confused. They suck.
-
I've just been cleaning stuff up and making sure everything is ok-ish. The ICV hoses were shot so I ordered new ones and PCV hoses. Also ordered new orange intake gaskets for the intake manifold to head and to throttle body. I am putting my stock exhaust from my sedan on so I ordered new downpipe gaskets and donuts for the muffler section. Also ordered new NGK plugs because it had funky Champion ones.
Rockauto has coil boots for 4.37$ ea. The listed brand is "Prenco" but the photo shows Bremi so I will let you know what I get. It said wholesaler closeout
Total spent so far, 460$ for the car, 142.47 from FCP, 30.90 from rockauto. 633.37
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login