Build Thread?
-
Got the trans off the motor today, took the clutch and flywheel off and stuck it on the stand!
Also was looking into clutches a bit, I think I will end up getting a clutch masters stage four setup. This would use the stock dual mass flywheel, a six puck rigid ceramic disc and an HD pressure plate. Called them up, guy was helpful and said it would be a great setup for up to 620 flywheel torque, and that the stage three would only be good to 425hp so that would be lame. The pricing is the same between the stage 3 and the stage 4 kit, so why be concerned about not being able to hold the power when its the same price?
$585 for the pressure plate and disc..... shit, this is going to get expensive real quick!
-
Alrighty, so I did some cleaning yesterday!
The motor was gross, as most motors are.
It all looked a bit like that to begin.
ignore the valve cover, that is getting special treatment
And the pile it left on the floor was ridiculous, filled up a dust pan!
Other than that, looking at MS setups, I think I will end up with an ms3x setup!
-
MS3x is the shit. You know I can help you with that Ben, looking forward to what you do.
-
Hi jake! I will do some reading today and get at you with some questions!
Sent from the future. Or my phone, who knows.
-
Ever see a transmission that was made and then sat in the warehouse its whole life? Me either!
But I did clean mine a bit
-
Got the head off recently, nice easy process without VANOS! I was a bit concerned about how the inside of the motor would look, but I was greeted by this!
Honing is still there, no ridge where the piston stops, no wear on the cams ect. Super happy with it!
Ordered new piston rings and rod bearings and am currently saving for ARP and MLS!
Anyone have recommendations on how to get the rest of the stock gasket residue off?
-
Use a RED Scotch Brite pad and some brake cleaner. Scotch Brite pads come in different abrasives; gray = fine, red = medium and green is rough.
-
They do make a semi long handled gasket scraper. Gives better pressure to get the old stuff off.
-
Anyone interested in a freshly build m50nv? I may be trying some new things lol
Sent from the future. Or my phone, who knows.
-
Well it just got new rod bearings, rod bolts, head bolts, all piston rings replaced, the head is going to be decked the smallest amount possible to make sure it mates well. Bore is beautiful, and you can has wiring harness and ecu if you need it.
Not sure what you had in mind for price, would you need the e36 oilpan? Because I still have that hanking around.
-
Idk, 600?
This isn't set in stone yet
Sent from the future. Or my phone, who knows.
-
Yeah.
Sent from the future. Or my phone, who knows.
-
Anyone notice that I suck at build threads? I do!
Got the head redone, looks real nice and shiny!
Got ARP studs and a .14 MLS gasket, painted the block a lighter gun metal grey (ha, get it?) and put it all back together, along with new piston rings and rod bearings and all new bolts. I have the turbo, its a holset HX35, ordered an intercooler.
Got a ZF, lots of stuff. All good fun!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better š
Register Login