Wrecked car won't start
-
Open the bleed screw and pour coolant into the reservoir until a steady stream comes out of the overflow. The crank position sensor will prevent the engine from starting, it is on the front of the engine just to the left of the water pump pulley. Do not run the engine for more than a minute without the serpentine belt operational. No belt = no water pump.
-
What kind of motor?
M52 motor, btw.
-
I think it's blown up and I'll even do you the favor of removing the car from you
Haha, this is the 3rd offer from people who could "take it off my hands"! I'm not convinced it's blown up quite yet!
-
Is that where the crank position sensor is supposed to be??! Looking at images there should definitely be something there... is it possible it hasn't been there for a while or can the engine absolutely not run without it?
Edit: Looks like that was the sensor position for OBD1 engines? I guess the mystery continues!
IT STARTED. After I unhooked the MAF and removed the air filter (maybe unnecessary), it started up. It had a really shakey idle for a bit then seemed to calm down. It smells absolutely terrible. Very exhausty around the engine and in the cabin. I now have a headache.
-
Hmmmm. So letting it idle for a bit, the only abnormal sound is the fan rubbing the duct tape I have holding my overflow hose up, since the fan shroud is snapped. I haven't attempted to drive it since it's still missing a front end.
Any idea what the bad exhaust smell is? Is that from continuous failed starts? Maybe put a lot of fuel in the cylinders or something? Maybe it's just from idling? Any ideas on that?
Here was the sound when it wouldn't start...
-
You may be correct on the smell from lots of cranking without firing. I have found with mine that if I start it just to move the car and shut it off without running it for more than a minute it will run very rough the next time I start it. I'm not sure if it fouls the plugs or why but my m50 and m20 and our Maxima are all that way.
-
You may be correct on the smell from lots of cranking without firing. I have found with mine that if I start it just to move the car and shut it off without running it for more than a minute it will run very rough the next time I start it. I'm not sure if it fouls the plugs or why but my m50 and m20 and our Maxima are all that way.
It sounds like your fleet of cars needs a tune up.
-
Have you pulled & inspected the plugs?
What happened to the car?
Hey narcosis! I have not pulled and inspected the plugs. I pulled a couple coils and looked down the tube to see if there was anything bizarre, but there wasn't. Maybe I should pull all the coils? I changed the plugs about 700 miles ago, so I doubt they're part of it... but if you recommend I still take a look I definitely will!
As far as what happened, I rear-ended someone. I have some pics on the "Well Crap :(" thread if you're curious.
-
It sounds like your fleet of cars needs a tune up.
They are freshly tuned, no issues there. Only happens when starting and moving the car a couple feet and shutting it off so that it only ran for 15-30 seconds. It will just run rough for a few seconds on startup the next time. Not sure if newer ones are better but try it sometime.
-
Is there some sort of "reset" button that needs to be switched after an accident?
My buddy had a Grand Marquis that didn't start until he google'd the issue. The Doc don't no des new cars...
@DrLeadFoot
-
Is there some sort of "reset" button that needs to be switched after an accident?
My buddy had a Grand Marquis that didn't start until he google'd the issue. The Doc don't no des new cars...
There shouldn't be.
The Grand Marquis has a fuel shut off valve that is standard on all Ford products. That thing can be set by hip checking the body or a loud subwoofer as well.
-
Checked down in all the plug wells (holes?) for oil, and didn't find any. It now starts even with the MAF plugged in but it runs a little rough. The car has a distinct vibration. Could this be because the fan is missing some fins? I wouldn't think that imbalance has much effect, but thought I'd add it
After letting it idle a few minutes, the temperature seemed fine, but the engine started to smoke from the area I show here: http://imgur.com/CGYmJAg
The smoke wasn't very thick, but was white/gray. It smelled 'burnt', but I'm not attuned to the standard engine smoking smells. It didn't smell sweet like coolant, but I don't know what burning coolant smells like!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login