'88 E30
-
I hope it gets here too Dan. I haven't had great luck with this project and ordering things ha. Garagistic, AKG, and now Enjuku
-
I haven't had much luck with vendors throughout this project. Don't they know I have a build thread to post on?
-
Well after no movement on the tracking, I got them to refund my money. A hollow victory because now I have my money, but I'm out 4 weeks of time. Thinking on just throwing money at a GC setup.......
-
#customerdisservice
its hard to go wrong with an e30 - GC/BC/ACDC they are all TNT
Dan
-
#customerdisservice
its hard to go wrong with an e30 - GC/BC/ACDC they are all TNT
-
Well ended up going with fortune auto coil overs. The 500 series. Ordered from AJ at endless, his prices were pretty good actually
After some talks with snap, I settled on 8k front, 12k rear. He did some maths and what not and reminded me about my upgraded sway bars and such. He also has experience driving a car with his hr setup and also johns car with the 10k/12k setup and he pushed me towards a happy medium
-
8k/10k you mean, right?
Yes i did mean that
-
Double checked my order to make sure haha. It is most certainly 8k/10k
-
Skid plate was very very close to the oil pan, I blame the chineseum core support. Made some spacers out of 1/8" flat stock to give some room between pan and plate
Then this
Now there's daylight (about a finger space)
Also noticed the steering linkage would bind a tad after putting everything back in so I filed the edge down barely.
Also did New VC gaskets and used some RTV to keep the oil where it belongs. "Reinstalled" my harness covers as well
-
#KaiserRollsMotorsports
Sell skid plate spacers, retire by 30
Banks HATE this one simple trick
Hahahah
-
Rear subframe went in last night
Only pic I took because I'm bad about that
-
what is the block you use between the jack stand and the car? i use wood block and destroy a couple every time i lift the car and its getting old.
Dan
-
what is the block you use between the jack stand and the car? i use wood block and destroy a couple every time i lift the car and its getting old.
Jackstands pads @ harbor freight.
Super nice to use. A tad squishy but very strong & don't hurt your car.
Think they are like $8 for two
Way more pics than necessary
-
+1 for hockey puck to avoid metal-metal with a jack under the diff or frame rails.
For jack stands Harbor Freight has those red covers that work OK on their 3/6 ton stands.
http://www.harborfreight.com/2-piece-rubber-pads-for-jack-stand-95952.html
A couple of layers of duct tape is another option to avoid metal on metal contact.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login