E21 Project Thread - Part 2

Bassboy3313

Passenger side done. Now to make a template and get cracking on the drivers side.

B C

Let me know if you need your hammers and dollies soon and I can give you my garage code. Otherwise I may be able to drop them by Friday evening when I get home

Bassboy3313

Thanks. They shouldn't be needed for this stuff, so you're good. No rush

Bassboy3313

Driver side wheel arch cut, welded and finished. On to mounting the rear flares...

Jdesign

Bassboy3313 said:

Driver side wheel arch cut, welded and finished. On to mounting the rear flares...

Man im stoked for this.

Bassboy3313

Rotted out trunk seal lip cut out, fabricated and welded in.

Bassboy3313

Started fitting the rear flares and figuring out where I need to cut/section them to fit better.

Bassboy3313

Group 5 roof spoiler installed

B C

No dust dix thank goodness

Bassboy3313

snap said:

No dust dix thank goodness

Bassboy3313

Was finally able to do more work on this. Got the passenger side rear flare cut, sectioned and fiberglassed back together. Used it to get the measurements and did the same on drivers side. Will just need some finishing with bondoglass and body filler before 2k epoxy primer and vinyl wrap.

Jdesign

Getting there. So will we see this road worthy this season?

Bassboy3313

Most likely not. Life's been getting in the way mostly

Bassboy3313

Well life has finally slowed down, just in time for winter ... uugh. Wish it was spring, but better late than never. Finishing up sanding and priming the rear flares so they can get vinyl wrapped. Then the rest of the car can be wrapped as well.