'88 E30
-
suspenceful said:
You never hang out with Ben, do you?
You never hang out with Mitch, do you?
I am a sarcastic douche most of the time
-
I'm sure the shop did this but make you look over all of the valve retainers super good. From everything I have read s50's built prior to 10/95 have retainer problems. The only reason I know this is because when I blew my motor up there were a couple ready to give out and let the valve drop.
-
I'm sure the shop did this but make you look over all of the valve retainers super good. From everything I have read s50's built prior to 10/95 have retainer problems. The only reason I know this is because when I blew my motor up there were a couple ready to give out and let the valve drop.
Assuming you replaced with 96+ retainers?
-
I am a sarcastic douche most of the time
You and I would get along just fine.
-
You and I would get along just fine.
He says after bashing me for it
-
He says after bashing me for it
No bashing here, just correcting him
-
did some VIN decoder stuff.
I have pre 10/95 build date.
new retainers have been ordered.
figure do it once and do it right so I dont have to worry about it
-
Good motto to live by.
https://www.instagram.com/_jdesigner_/ http://nevertoolow.tumblr.com/
🥳SOLD BMW E24 633CSI - BMW M30B32 🧪SOLD HCH ES9 - 1.3 LDA
👽BMW E30 325IC - Toyota 1JZ-GTE ⏰ HONDA EF9 CIVIC SI - JDM B18C5
☠️BMW E36 318i - Ford 5.0 FE302 🚴♂️ GT-Labomba - 26x2.75 Freeride
🤹♀️SOLD BMW E36/7 Z3 - BMW M54B25 🧓SOLD BMW E10 2002 - BMW M10M05 -
No updates in a month, nice. I haven't done anything to it yet. Retainers showed up. Still haven't ordered anything else, nice
-
nice
-
No updates in a month, nice. I haven't done anything to it yet. Retainers showed up. Still haven't ordered anything else, nice
Order your HG already.
Burnouts on your face was not an idle threat. -
Does it run yet?
If I was a mod I'd ban you
-
Does it run yet?
-
Ordered parts, leave me alone
-
Get those parts installed.
Hurry up already! -
Ordered the following
Cutring headgasket
Beisan anti rattle dealio
VC gasket
Vanos gasket
Axle lock plate
Gasket for heater core port on back of head
That should be everything needed to get the head back on and such. And to put in a replacement axle
-
Also the new retainers are installed
-
Ordered a stone for the block, time for some "resurfacing"
Was going to tackle that this weekend, but Brooke and I are going to USAIR for an autocross event. The track at shawano is insanely cool (lots of elevation changes and overall a tighter track)
I'll be co-driving her Miata. I'll be sure to fire up the Gopro's and post some hairdresser nonsense up
-
Hooray
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login