The E46 M3 Journal
-
Maybe if the starter would apologize for what he did then the SMG would talk to him again... if only the starter knew what he did wrong.
Replace "starter" with "husband" and "SMG" with "wife"........
-
My issue:
The trans is physically in neutral and still in 0.
- Brand new key from BMW.
- 12.4 volts on the battery.
- The starter works fine and turns the engine over after testing it.
- Replaced the salmon relay with one I know was working.
- No blown fuses, #14 & #30 are good and tested good.
- Hydraulic fluid is filled topped off in the reservoir.
- Hood is closed.
- SMG shifter unit tested and is sending a signal. (Flashes 0 and doesn't go into 1 or R)
- New clutch installed.
- New transmission shift springs.The car won't start or shift out of 0 into 1 or reverse. Yellow SMG light is on and it just flashes 0.
A BMW tech came over and hooked up the computer and there is something not talking to the starter telling it to start. Should I have him reset the system? Bleed it? Bad slave cylinder? I think the SMG system might have been upside down and leaked some fluid from the reservoir hole.
There was water in my SMG circular connector but I cleaned it out and sprayed electrical connector cleaner all over it and blew it out with an air hose.
Please help!!!
@DrLeadFoot
-
Does the trunk have to be closed to start it?
@DrLeadFoot
-
Close the trunk to try lol
All these demands!!!!!
@DrLeadFoot
-
It does not start with the trunk closed.
The SMG pump primes just fine when the car is unlocked.
@DrLeadFoot
-
-
foot on the brake? satanic chant completed?
Did that to no avail.
I feel the smg is preventing the car from starting.
Trying to download DIS_v57 now through a torrent file.
Sent from my SM-G900V using Tapatalk
@DrLeadFoot
-
A friend let me borrow his computer with the DIS and INPA software. The labtop turns itself into a virtual machine but it won't connect to my car.
The ignition is on but it won't read.
Sent from my SM-G900V using Tapatalk
@DrLeadFoot
-
Thing won't shift into gear. Flashes 0. Not sure what's up. I know if measures the psi on the slave to make sure the clutch is disengaged.
Hood is closed. Hood latch sensors plugged in. Ugh!!
Matt from Urban Motorworx came over. They key chip is talking to the computer. Getting a failure to start.
The shifter is outputting a signal. Switched the smg relay from the old motor that I know works.
Fuses 14 & 30 tested good.
SMG fluid is topped off.
I cleaned off the smg harness connector. With electrical cleaner. It had water in the connector and protective cover.
Oil level sensor?
I think the smg needs to be bled because it isn't shifting into gear when the key is on.
Sent from my SM-G900V using Tapatalk
@DrLeadFoot
-
Is a traditional 6spd a huge endeavor to swap? Im sure the dealer will get this all sorted out quickly but just curious if the swap is more hassle than its worth/better off buying a non-smg
All I would need is a bell housing, a third pedal and shifter linkage. Probably some other odds and ends. The gearbox on the smg is the same as a 6 speed.
Want to keep the smg so the wife can drive it.
Sent from my SM-G900V using Tapatalk
@DrLeadFoot
-
Snap said:
Is a traditional 6spd a huge endeavor to swap? Im sure the dealer will get this all sorted out quickly but just curious if the swap is more hassle than its worth/better off buying a non-smg
All I would need is a bell housing, a third pedal and shifter linkage. Probably some other odds and ends. The gearbox on the smg is the same as a 6 speed.
Want to keep the smg so the wife can drive it.
Sent from my SM-G900V using Tapatalk
Teach the wife some clutch kicking!!
-
DrLeadFoot said:
Snap said:
Is a traditional 6spd a huge endeavor to swap? Im sure the dealer will get this all sorted out quickly but just curious if the swap is more hassle than its worth/better off buying a non-smg
All I would need is a bell housing, a third pedal and shifter linkage. Probably some other odds and ends. The gearbox on the smg is the same as a 6 speed.Want to keep the smg so the wife can drive it.
Sent from my SM-G900V using Tapatalk
Teach the wife some clutch kicking!!
She was in New York City for 9 years right after high school without a car. She has been practicing her skills on the 2001 Cherokee. We're taking the ultimate driving experience slowly.
Sent from my SM-G900V using Tapatalk
@DrLeadFoot
-
@DrLeadFoot
-
I don't know what I'm doing but it is talking to the car!!!
Sent from my SM-G900V using Tapatalk
@DrLeadFoot
-
Got the INPA up and running. Does this mean I need to bleed my clutch? Help!
Sent from my SM-G900V using Tapatalk
@DrLeadFoot
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login