Build thread/running log of my E28? Guess I can do eet.

[Earl]

So are you doing a mild shave and tuck?

[jc43089]

That sounds kinda personal...

[Brian.]

Shave? Eh. I'm just getting rid of the un used factory brackets. a tuck? Not really, tucks are stupid. I'm just making the engine bay look more representable. The drivers side of an E28 is a traffic jam of hoses and wires.

[Earl]

So if you clean up the wires, that is a tuck

[Brian.]

Wrong, a tuck is "TUCKING" the wires behind, in and or under something. I'm just rerouting them in the engine bay to not have a mixed not of coolant hoses, brake lines, power steering lines, and wires all twisted around each other like they came from the factory....

[Brian.]

Pulling my head apart soon to enlarge the ports, as well as a port an polish, then getting errything hottanked!

[Earl]

A mild tuck would consist of rerouting wires and making them look more appealing. Making them disappear is a full tuck.

[jc43089]

He wants to clean it up, but not be associated with fully tucked stance hoodlums... haha

[Brian.]

jc43089 said:

He wants to clean it up, but not be associated with fully tucked stance hoodlums... haha

Kinda, even though I am stanced pretty good.

[Brian.]

Got the engine torn down a bit more yesterday before work. Coming along slowly, but I got all the time in the world.

I also cut off the rusted rear muffler because I was afraid it'd fall off on the highway an explode into a rust bomb. This is what was left:

This is also the car I picked up off Jawa for a good price. Yay winter beater!

[Brian.]

Did a little work on the daily, the rear muffler was a bit rotted out, decided to remove it, didn't realize just how bad it was...:

Started tearing the motor down to a bare block to get it ready for hot tanking, primer, and paint.

This motor was rusty an crusty on the outside. But a bit of wire wheel action, and a bit of sand blasting will get this thing looking minty as ever!

Cylinder walls had no scoring, no ridging, so that's good!

Pistons looked pretty good for the miles as well!

The crank looks to be nice as well. It has no scoring, no scratches, etc. So I'm all around pretty happy!

An this is how I left it. No sleep with a work in a few hours, I needed some rest!

[jc43089]

I used cast blast paint on the m20 I built, color looks like fresh blasted cast, not sure how it holds up but the guy who looked did my block work recommended it.

[Brian.]

That looks good I'm looking for something like that o a bit more

[jc43089]

Brian. said:

That looks good I'm looking for something like that o a bit more

Eh??

I don't know what the paint is on the head, that was on when I got it (reman)

[Brian.]

Sorry, posted from my phone. I want it to look a little more shiny then that. I'll try to find a photo

[Brian.]

This is the look I'm going for for the block.

[Earl]

Like mine?

[Brian.]

Still not as shiny as I'd like. That looks like typical vht

[Earl]

Mine isnt vht. It is a very metallic duplicolor engine enamel. Doesnt look as shiny in that picture as others

You can see somewhat where the sun hits it here

[Brian.]

Possibly. I like the SR20's color better. really pops. Which is nice, considering 90% of the M30 block is masked by a gallon sized starter, and a stupid as fuck intake design. SO the bits that will show, will look like a sex machine in the shadows.