WIBIMMERS

If you want to come up to the Appleton area, I'd do it for a reasonable price on a Saturday/Sunday.

Earl said:  They could get out of sink [image: SInk.jpg]

patsbimmer1 said: If yoy want to bring the car by on Sunday afternoon I can take a look then. Awesome, that works for me! I don't think I have your number any more, so if you could give that to me, that'd be great.

I'm planning on purchasing M3 control arms and the Bilstein B12 kit.  Can somebody recommend a good shop in the Madison area to have these installed?  Is there anything else I should get done while I'm having these installed?

4-6hrs for valve covet gasket. 3.5-4.5hrs for oil filter housing. Low end of the scale being bmw warranty labor hours.

Accurate Alignment & Frame near Zimbrick Honda off Fish Hatchery does great work.  He installed a shim kit I supplied to dial in some neg. camber for me.  My e36 ti never handled better. Cash or check only though...

reckedhim said: Yea, I think that's where I'd run into my biggest problem as I've never coded anything before.   You need either inpa or ista/d and a KCAN cable to code them. Send you a pm.

Oof, I would just buy a vrsf exhaust and spend a few hundred dollars more than doing the PE mod for $400. Let me know how the DIY goes!

reckedhim said: That sucks that they won't do anything about it.  I took mine to Zimbrick in Madison and it was there for a few hours and they called me and told me they were going to replace them.  They were very easy to work with. I had the same experience at Zimbrick.