Clutch alignment tool

[nick.e46.330i.]

Does anyone have one laying around I could borrow for a week or 2? It would be for my 2003 330i 

thanks in advance.

[jc43089]

Do you know the pilot bearing size and whether it is a coarse spline clutch like an e36?  I will look at home, if nobody close has one I could mail you one.  Chris Young might also have a couple from me too. @YoungCR

[Earl]

If an m20 one is the same, I will bring mine Saturday

[Jeff]

I have one also pm me if you would like

[jc43089]

I have a 10 spline with a 10mm pilot ID. A 24 spline which is for an m20 I think, and a 21 spline which might not even be for a BMW.

Sent from my 831C using Tapatalk

[jc43089]

On second look the 24 spline is for a Nissan so 10 spline with 10mm pilot is the only BMW one I have now. Which is used for an e36.

Sent from my 831C using Tapatalk

[nick.e46.330i.]

An e36 one would work. I'll message you both Jc and Jeff.

[Earl]

If that's true, an m20 one would work too (since I have an m20 clutch for my setup). I can bring my tool Saturday

[nick.e46.330i.]

Earl said:

If that's true, an m20 one would work too (since I have an m20 clutch for my setup). I can bring my tool Saturday

Sounds good. See you Saturday earl

[jc43089]

It might just be a difference in pilot bearing size.  The one I have is for the small style, 10mm I think.  I think all the clutches are 10 spline.

[YoungCR]

jc43089 said:

It might just be a difference in pilot bearing size.  The one I have is for the small style, 10mm I think.  I think all the clutches are 10 spline.

Pretty sure this is correct, the two you gave me were 10 spline but different sizes. I can't find where I put them though to confirm