BMW v8 engine coffee table project
-
intake manifold done.
throttle body and pcv installed with new hardware
injectors painted blue for a little color. the studs/nuts above them are the inside mount for the glass piece to rest on, made from all m60 parts.
hopefully it will look good once all together, but i can always change it.
Dan
-
What kind of oil are you using for break-in?
due to the light use, I'm thinking EVOO.
Dan
-
so got the block all buttoned up. painting done. foot hardware and bearing caps installed.
created a 'headgasket'. i didnt want the paint between the head/block to adhere over time. plus it gives it the correct look, as you can see the gasket between the two.
i will be mounting the heads to the block with just four head bolts each. all 20 would be overkill.
Dan
-
also getting pretty close to done, all i have left is to paint the valley pan, figure out my plaque, finish polishing some odds and ends like plugs on the block and intake manifold hardware.
Dan
-
-
no valves in the head. no point in reinstalling all that when it can't be seen. same reason for no crank/pistons. it also saves weight. the bag of valves/springs must weigh 8lbs and obviously the rotating assembly is a bit more.
Dan
-
-
pure awesomeness!!!
-
valley pan done. brand new mounting hardware used. painted copper because it will be fairly hidden by the intake and will just disappear if it left it aluminum. also, copper kicks ass.
Dan
-
This is really cool. So many details!
Also, that looks like the ark of the covenant or something hiding in there.
-
I was finally able to see the pictures! So when are you going to start selling these???
-
I was finally able to see the pictures! So when are you going to start selling these???
when this one goes up for sale.
Dan
-
Me likey copper!!!!
-
well the intake mani seals i pulled from my actual car were almost in brand new shape even after 130k miles, so i decided to add them to the project.
i am now 99% done with the table. all i have left is to get a plaque with the technical deets on it. deciding between etched glass or laser engraved aluminum.
photoshoot to come...
Dan
-
Etched glass as in etched on the top itself?
wont that get ruined by spilled pop, pizza, juice boxes, those little white speckles on sno-caps and mess up doing lines of coke on the top?
I vote laser engraved plaque!
lol lines of coke.
glass would be etched (in reverse) on the bottom of the glass. leaning towards the plaque since its possible for the glass to be lost or broken.
getting quotes/feasibility from a few places, but if anyone has a source for this sort of thing i'm all ears.
Dan
-
ok so no update in a while for a number of reasons, but mainly i had to move this month so i didnt want to do final assembly only to tear it down and do it again.
here's a sneak preview of all the parts, should be together in a couple days.
Dan
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login