Alpine e30 progress/build thread
-
you dont need to clean the car for night shots!
If I didn't have a small oil drip, and the car wasn't as low to maneuver Milwaukee roads, I'd also like to bring mine down for some Milwaukee back drop pictures.
top 4 in the nation, baby. https://www.teletracnavman.com/resources/resource-library/infographics/worst-maintained-roads-infographic
lol head over anyways!
Dan
-
you dont need to clean the car for night shots!
top 4 in the nation, baby. https://www.teletracnavman.com/resources/resource-library/infographics/worst-maintained-roads-infographic
lol head over anyways!
41 to 94 and getting off by the art museum isn't too bad. It's pretty much everything else.
-
41 to 94 and getting off by the art museum isn't too bad. It's pretty much everything else.
Can confirm. I live in the Van Buren/State St. area when at school and most of those roads are horrendous. 6" holes (generally propagated from pavement seams) are not unheard of on side streets.
-
its decided then, e30 shoot at the museum. what night? i have nothing going on, you know quarantine and all.
Dan
-
I did accidentally re-set some of the DTC suppression so I get a check engine light again, so I'll have to go back and re-do that.
Turns out they were just old codes that somehow made it through the flash. They must be stored somewhere else. Cleared and never came back!
-
157.8k
Had a few moments to work on the car over the weekend, so I finally wired in a pair of early e36 window switches and pigtails. Got them wired in and both the switches are bad. Nice!
One switch only works sometimes, the other only goes down. The behavior follows the switches when swapped so my wiring is good at least. I took them apart and they look a little corroded. Going to try and clean the contacts and re-solder any joints. If that fails I'll just have to get some new ones.
-
157.8k
Had a few moments to work on the car over the weekend, so I finally wired in a pair of early e36 window switches and pigtails. Got them wired in and both the switches are bad. Nice!
One switch only works sometimes, the other only goes down. The behavior follows the switches when swapped so my wiring is good at least. I took them apart and they look a little corroded. Going to try and clean the contacts and re-solder any joints. If that fails I'll just have to get some new ones.
Try cleaning the contacts up, I have had intermittent e30 window switches and cleaning fixed them. The full current goes through the switch and the arcing pits the contacts.
-
Try cleaning the contacts up, I have had intermittent e30 window switches and cleaning fixed them. The full current goes through the switch and the arcing pits the contacts.
Same, You should be able to just clean them to revive them
https://www.instagram.com/_jdesigner_/ http://nevertoolow.tumblr.com/
🥳SOLD BMW E24 633CSI - BMW M30B32 🧪SOLD HCH ES9 - 1.3 LDA
👽BMW E30 325IC - Toyota 1JZ-GTE ⏰ HONDA EF9 CIVIC SI - JDM B18C5
☠️BMW E36 318i - Ford 5.0 FE302 🚴♂️ GT-Labomba - 26x2.75 Freeride
🤹♀️SOLD BMW E36/7 Z3 - BMW M54B25 🧓SOLD BMW E10 2002 - BMW M10M05 -
Windows go up, windows go down
Cleaning the contacts worked great. I was able to get a thin strip of sandpaper between each contact in the switch to clean up any pitting and corrosion then sprayed them down with CRC contact cleaner to remove any oils/debris. Each direction went from many ohms (one was almost 200) to under 3 when closed. One of the contacts looks like it had actually gotten hot at some point so there was definitely a ton of resistance there.
it turns out the write-up I followed for the wiring was wrong and my switches are backwards lol. That's what I get for not checking the pinout. After daily driving e36's for a number of years it felt wrong immediately, so I'll flip it around eventually.
-
One of the contacts looks like it had actually gotten hot at some point so there was definitely a ton of resistance there.
I cleaned up my window switches this winter and I had the same thing. A couple of the contacts were black. Not sure what would have caused that, but it was a little unsettling seeing that when I took them apart.
-
Time for a plush dash mat
-
-
158.5k
Drove it across a truck scale near my house for fun last night. Subtracting my weight it came in at 2,720lbs with a full tank of gas. Stock 318is curb weight is ~2600, so I was initially a bit bummed I'd added 130lbs with the swap... But, when you consider I had a trunk full of stuff and a roof bike rack setup on it at the moment, that's actually not too bad!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login