ClassE 1989 325IS Build Thread
-
I decided last weekend I will be going with air next winter, roads are just too crappy to be low static.
Wheel bearing time - and giubo/CSB time!
CALLING DIBS ON THE CATUNED COILS!!!
-
CALLING DIBS ON THE CATUNED COILS!!!
Noted.
-
Bolt on a 24v swap
-
-
Your subframe is lowered and your diff is lowered quite a bit. That is bad news bears for your U joints and driveline angle.
Even the lowered subframe is not great
It's not a CV joint so it will throw some serious vibes if it is outside of its allowable range.
I still have the back half of a good shaft if you need it. -
Your subframe is lowered and your diff is lowered quite a bit. That is bad news bears for your U joints and driveline angle.
Even the lowered subframe is not great
It's not a CV joint so it will throw some serious vibes if it is outside of its allowable range.
I still have the back half of a good shaft if you need it.
I think the current plan is to swap the CSB and Giubo onto the original driveshaft - and bring it in to be balanced. If it balances out good it'll go back in... If not - I'll have to address then.
-
If your U joints are shot you will still get some clunking back there, the joints shouldn't have any play.
-
No play and there shouldn't be a lot 'sticky' spots when you move the joint around.
@DrLeadFoot
-
-
Dat m70 manifold though
YOU SEE NOTHING!!!
Not sure I'll be using that - might have a slight change of plans in mind for the intake manifold.... We'll see how the summer pans out.
-
Shift linkage is rebuilt and back in.... And it was a monumental PITA. Thankfully it was worth the headache because the shifter feels fantastic.
Electric fan is mounted and radiator mounting is done. Gotta figure out fan wiring and figure out what I'm gonna do for an upper rad hose.
Hopefully tonight I can yank those rear diff spacers and remove the no longer needed accessory crank pulley. I'm assuming I should get shorter bolts to replace the existing ones - or add washers?!? Will have to figure out tonight.
-
YOU SEE NOTHING!!!
Not sure I'll be using that - might have a slight change of plans in mind for the intake manifold.... We'll see how the summer pans out.
Budget = ITB's
-
Budget = ITB's
I can neither confirm nor deny anything.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login