My name is Earl, and I have a Stainless Steel bolt fetish =)
-
Didn't get much of anything done on the compact this weekend but I do have pictures.
My friend wasn't able to make it out to work on the bay so I decided to just quick stop by Sunday.
I got this guy installed:
I also rounded up a few things I want to get powdercoated:
The dust shields are coming off of the knuckles because they are shot and I won't have much use for them=)
I also took some pictures of being aired out on the 15's. It just looks funny with how sunk they are.
-
Looking good as usual Earl!
-
I stopped out at the shop Sunday hoping to do a bit of work but it was way too cold. I grabbed my calipers and front knuckles to pull apart at work this week.
I am in the middle of breaking down the knuckles and will be doing the calipers sometime this week. The 46mm nut on the knuckles is going to be a fun one. It is supposed to be on at 221 ft/lbs.
I am breaking this all down in preparation for powder and new hubs. I need to find some rebuild kits for the calipers since I am splitting them. Has anyone found a good place? I have been told Autozone and will be calling them after work for pricing.
-
I started with the knuckles by removing my Motorsport Hardware studs.
As you can see, they have been around the block a few times.
I then tapped the safety tab out on the nuts and removed them.
The inner race was left behind.
I thought it would be hard to remove but I was able to slide it off with two screwdrivers underneath.
I removed my ABS sensors next since the ABS is deleted.
I also removed the dust shields and threw them in the trash.
They were now ready for some cleaning.
I taped up the spindles to keep them from being damaged by the sandblasting.
I then got them as clean as I could and ready for powder.
The next thing to tackle are disassembling and prepping the calipers and carriers.
-
Have you tried metro auto parts? They seem to have the oddball stuff most the time. I mean, they had rebuild parts for my e21 calipers. Just another thought.
Sent from my XT901 using Tapatalk
-
Have you tried metro auto parts? They seem to have the oddball stuff most the time. I mean, they had rebuild parts for my e21 calipers. Just another thought. Sent from my XT901 using Tapatalk
Andy looked and they don't look like they carry the seal kits=/
I started yesterday but removing my old front lines, all of the pads, and then the carriers.
I will be removing the pistons from the calipers today. Yesterday I couldn't find a rubber tipped air nozzle to be able to blow them out with compressed air.
I got the carriers all cleaned up and ready for powder too.
I looked into the pricing for the carrier bushings, carrier guides, anti-rattle clips, bleeders, and new mounting bolts and was blown away.
It is about $200 to buy sets for both the front and the back. There are brass carrier bushings that end up costing almost $20 less when getting everything else. They take away the side to side give that the rubber bushings have, making the pads wear flatter under hard braking. They aren't really neccessary for me since I won't be pushing my brakes to the limit, but I am not sure if it will hurt upgrading to them to cut down on cost. In my head upgrading sounds like it makes sense instead of paying more for factory bushings.
Has anyone ran brass carrier bushings on their calipers? This is turning into an overpriced nightmare=P
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login