Non-BMW Stuff on a BMW Forum

gilber33

Getting closer and closer.

B C

I haven't really been around for a while. So this is a spare engine that you are cleaning up. Did you change the head gasket or do any internal refreshing? It would look just great sitting on the stand in the garage even if you never intended to use it! Engine dress-up is my favorite part of wrenching. You've done well@

Boris3

Beautiful powdercoating job! Engine looks great.

gilber33

snap said:

I haven't really been around for a while. So this is a spare engine that you are cleaning up. Did you change the head gasket or do any internal refreshing? It would look just great sitting on the stand in the garage even if you never intended to use it! Engine dress-up is my favorite part of wrenching. You've done well@

This is the engine I did some work to when I first got the car, but when I parked it for the winter I noticed the RMS was weeping a bit. So I pulled the engine out to replace that. I do have a spare engine that I plan on cleaning up and would like to do some internal refreshing on that one.

I was going to swap most of the stuff from this one over to the new engine rather than powder coating a second set of everything, but I agree with you that this engine would look really nice just sitting on a stand in the garage ultimately. haha

gilber33

Other than a couple small things to put on the engine is ready to go back in.

Lightweight flywheel

All set

Spare block on the stand

YoungCR

Looking good! The spare motor is the one that came with your car correct?

gilber33

YoungCR said:

Looking good! The spare motor is the one that came with your car correct?

Thank you! The spare motor is one I just picked up actually. The one with the PCing came with the car. I had it out last year and did a bunch of refreshing on it, but noticed the RMS leaking when I parked it for the winter. So, back out, redid a bunch of the powder coating from silver to wrinkle black, light weight flywheel, and a some other stuff.

gilber33

A few beers later and with the assistance of @rampelsauce, the engine is back in. Zach left with a small Tupperware of brackets for PC. Loving the wrinkle black more and more.

gilber33

New steering wheel in and mocked the front up. Gotta take the bumper back off to hammer in the tow hook bumper support some more and make sure all the headlight adjusters spin.

gilber33

Got a little more of the engine back together.

Also, working on putting in the M3/318is engine harness covers. The harness in the car was so stiff from 30 years of being in the same position so I had to pull out the harness and trim off the rubber coating. Will mock it up and then wrap it in the fabric harness tape.

gilber33

This was way more difficult than it needed to be.

GunMetalGrey

It looks nice with the wiring all tucked up in there!

Jdesign

But the results are WELL WORTH IT!

gilber33

Jdesign said:

But the results are WELL WORTH IT!

Yes, in the end it was worth it. Also got new headlight covers to help clean up the front of the engine.

gilber33

Getting the engine almost all put togrther. Accidentally tossed out the radiator rubber mounts with the old radiator so waiting for new ones of those to finish that up.

rampelsauce

The old dirty delphin is looking good! Can't wait to own it again after you get bored.

gilber33

Lol. Well, lots of credit to you for so much of the powder coating in there.

Jdesign

Looks very nice indeed. Getting close!

gilber33

Other than the exhaust a few small things in the engine, the big stuff is all done. Last few to do's are remote door lock thing install, new head unit that blends in better than the cheap one I got last year, would like to attempt to peel the tint off.