chit chat thread
-
So I bought an '04 Sienna van with a bad transmission. It had been power flushed and that caused a plugged filter about 1000 miles later. It was a good price due to being broken. I towed it home and changed the filter and fluid, that got rid of the cavitating pump noise and it drives but the shifting is poor, harsh 1-2, weak 2-3, then 3-4-5 works ok.
Last night I pulled the valve body to disassemble and clean it, I am going to try that first, if it still doesn't work I'm not out anything. Most likely I will be hunting for a U151F transmission.
I didn't get any pictures because my phone died but yikes there are a lot of small passages and valves in the valve body. It's like black magic going on in there, several spools seemed sticky so I have a small amount of hope that it might solve my problems to clean it all carefully.
-
This is more like undriveable bad shifting. The 06 and newer on has the same transmission but uses Toyota "WS" fluid rather than 04-05 uses "TI-V" the programming is different I think to match the lighter viscosity fluid. I usually use Redline synthetic, the TI-V compatible fluid is their D4, they would recommend D6 for newer vehicles that require "WS" fluid.
I will be adding some Lucas tranny doctor to this one for good luck...
Fun fact, this '04 is an XLE Limited and has radar following cruise control, I doubt it works anymore but I did not know the was an option so long ago.
-
In 2004 they had adaptive cruise control, but it was $$$ option. Getting to be standard equip nowadays...
I'm almost 100% sure you'll be looking for a new tranny.
How many miles on it?
- 2011 335xi Coupe Black Sapphire Metallic (e92/N55/ZPP/ZCW)
- 2011 335xi Coupe Deep Sea Blue Metallic(e92/N55/ZPP/ZCW)
-
In 2004 they had adaptive cruise control, but it was $$$ option. Getting to be standard equip nowadays...
I'm almost 100% sure you'll be looking for a new tranny.
How many miles on it?
172k. I'm sure it's toast but I like taking stuff apart and i'm not out anything but an evenings work if it still doesn't work.
-
172k. I'm sure it's toast but I like taking stuff apart and i'm not out anything but an evenings work if it still doesn't work.
It is definitely fun taking stuff apart. Like when I changed the starter motor in my 335. What a PITA! I curse that one bolt in the back of the motor! Three inches from the firewall. WTF, BMW?!?! But I got it all back together and believe it or not, it works!
- 2011 335xi Coupe Black Sapphire Metallic (e92/N55/ZPP/ZCW)
- 2011 335xi Coupe Deep Sea Blue Metallic(e92/N55/ZPP/ZCW)
-
It is definitely fun taking stuff apart. Like when I changed the starter motor in my 335. What a PITA! I curse that one bolt in the back of the motor! Three inches from the firewall. WTF, BMW?!?! But I got it all back together and believe it or not, it works!
A flex head wrench is the key there.
-
A flex head wrench is the key there.
Ya! I found that out later. Plus the universal size for that F... er.. what I meant to say - FINE E-torx - I just bought a set of ratcheting ones from Sears and they are very nice.
- 2011 335xi Coupe Black Sapphire Metallic (e92/N55/ZPP/ZCW)
- 2011 335xi Coupe Deep Sea Blue Metallic(e92/N55/ZPP/ZCW)
-
I'm trying to get our hardwood floors refinished but for whatever fucking reason getting someone to show up and give me quotes is like pulling fucking teeth. It shouldn't be this hard to spend money.
-
I'm trying to get our hardwood floors refinished but for whatever fucking reason getting someone to show up and give me quotes is like pulling fucking teeth. It shouldn't be this hard to spend money.
It always seems to happen when you want something done you can't give your money away nor will people show up if you try to give them extra money
1976 530i e12
1990 325ix e30
1992 325i e36
1995 740il e38
2001 330xi e46
^More to come
-
It always seems to happen when you want something done you can't give your money away nor will people show up if you try to give them extra money
I'll take any extra money you have laying around...
Hardwood floors should be a DIY. You'll save a lot of money and learn a new trade. That's why I put my own tile floor in my basement. OK, it was a PITA, but I learned a trade and also learned why I don't do that trade for a living...
- 2011 335xi Coupe Black Sapphire Metallic (e92/N55/ZPP/ZCW)
- 2011 335xi Coupe Deep Sea Blue Metallic(e92/N55/ZPP/ZCW)
-
I've got no issue diy'ing stuff but our hardwoods are 100+ years old so i'd like to not fuck them up. That and my August/September is packed between work and 4 weddings. One guy did get back text me after I sent him pictures. $3 per sq ft to refinish the floor and it's about 500sq/ft.
-
I've got no issue diy'ing stuff but our hardwoods are 100+ years old so i'd like to not fuck them up. That and my August/September is packed between work and 4 weddings. One guy did get back text me after I sent him pictures. $3 per sq ft to refinish the floor and it's about 500sq/ft.
That's actually not a bad price.
- 2011 335xi Coupe Black Sapphire Metallic (e92/N55/ZPP/ZCW)
- 2011 335xi Coupe Deep Sea Blue Metallic(e92/N55/ZPP/ZCW)
-
That's actually not a bad price.
That's what I thought.
-
Comrades!! Does anyone have a spare metal thermostat housing for an M50? I may have accidentally broke mine
Yes
well there's thatHello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login