ClassE 1989 325IS Build Thread
-
Well - had another good night in the garage last night. Pulled subframe back out, flip-flopped subframe bushings and removed subframe spacers and reinstalled. We had some issues getting the metal sleeves that run through the subframe bushings into the underbody "pockets", but half an hour of wiggling and "adjusting" with a BFH they finally slipped in.
The weld-in camber plates clear the underbody now.... But not by much. I do have acouple questions:
-Do I reinstall the original large washers that were sandwiched between the subframe bushings and body? I did - just wasn't sure if I was supposed to.
-When I drop the big rear suframe bolts through the holes/bushings about 1/2" is sticking down through the bushings. I was expecting more - so tried tapping the bolt down with a socket extension but it didn't seem to want to go down. Does 1/2" of thread sound about right? When you tighten down the nut from below, does the splines of the bolt seat down and gain me more thread?
-I've seen 70ft/lbs for the subframe nuts - and "get tight as possible". Thoughts on torque spec?
-
on mine, I torqued them to 70 lb-ft ish or whatever the spec is and it didn't seem quite right to me so I snugged them down by feel.
I couldn't find anything on the trailing arm torque specs so I checked for free motion without the shock attached and snugged it down until it started to bind just a bit, then backed it off to where it still freely rotates, I used nylock nuts and loctite.
Also, yes, the washers get re-installed, otherwise the shear area on the bushing will be reduced and will wreck the bushings sooner
-
Well - had another pretty good night!
Subframe is up and bolted in, rear coils are in, ebrake and driveshaft are bolted in, rear seats are in, new front sway bar end links and steering boots are in, new front tie rod ends are in.... Didn't install the new swaybar bushings though when I ran across this:
Apparently the passenger front sway bar bushing mount was broke/stripped at some point and a PO or shop did this. I'm going to leave bushings "as is" until I can replace the front substructure.
-
I've always had a "thing" for wood wheels - but I do have to admit I'm undecided on if this one is gonna stay. The same wheel with brushed silver center - but wrapped in black leather - could be on the "to do" list.
I've got a long list of stuff to do though before I get to that point!
-
Dude..... Hell yeah!!
That thing is looking good!!
@DrLeadFoot
-
YES!!!
NSFW.
Sent from my SCH-I535 using Tapatalk
@DrLeadFoot
-
Looks fantastic. Hopefully you make the e30 meet!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login