UUC DSSR?

[B C]

I have it, its a good product, but you could make the same thing if you have a basic knowledge of machining.  

I dont regret buying mine though.

[ClassE]

I have no idea what the hell you're talking about - fill me in so I can haz the noledge.

[B C]

[KaiserRolls]

Snap said:

I have it, its a good product, but you could make the same thing if you have a basic knowledge of machining.  

I dont regret buying mine though. 

do it for the boomstick

[ClassE]

Because racekor!

Add that to my "crap I gotta buy" list! What's something like that go for?

[KaiserRolls]

ClassE said:

Because racekor!

Add that to my "crap I gotta buy" list! What's something like that go for?

http://www.uucmotorwerks.com/dssr/

http://www.turnermotorsport.com/c-178-bmw-dssr-uuc-double-shear-selector-rod.aspx

[ClassE]

Damn.... Not "a lot" of $$$ but enough to not have me order one right away. Thanks for the lessons - lots of learning when switching to a new platform!

[REKIII]

I have it on mine.  Nice piece.

[Earl]

Now you guys are making me want one.....someone here with a lathe should start making these=)

[Rowleym]

Ill make one for you queers. Same length as stock?

[Earl]

Yes please. I was going to say "Paging Rowley" but I am not a ghost whisperer so...........

[Rowleym]

Earl said:

Yes please. I was going to say "Paging Rowley" but I am not a ghost whisperer so...........

You caught me with your telekinesis. Anything else I need to know? I should be making one tonight. What type of steel?

[B C]

I would say 304 stainless, and use oil-impregnated bronze sleeve bearings in place of bushings.

[Rowleym]

I was under the impression the double sear rod was the only needed solution. Need to replace those bushing as well eh? 

304 stainless why? We don't carry stainless so I would have to order it.

[B C]

Id replace this plastic bushing with a bronze sleeve bushing ^^^ 

304 because aluminum is too soft and plain carbon steel might rust to the pin that goes through the middle/nobody likes rusty parts

[ClassE]

I could have them zinc coated up by me for cheap.

[andyhundley]

So should I buy one from UUC? Haha

[B C]

it was annoying for me seeing how simple of a part it is and that it could be made yourself for less money, but the cost had to be looked at as paying for the convenience of not having to make it. 

Time is money, money is time, and there is never enough of either of them.

[wasnt m3]

I'd be interested in on for my m3. Planned on installing a new shifter soon.

[Bassboy3313]

Snap said:

Time is money, money is time, and there is never enough of either of them. 

Amen brother!